Leaf Eater Advanced

Rain Heads

logo-leaf-eater-advanced

Description Code
Leaf Eater Advanced™
90mm RHAD01
100mm RHAD02

logo-vh-pivot-outlet logo-clean-shield

logo-mozzie-preventionlogo-paintable

THE NEXT GENERATION IN RAIN HEADS

The Leaf Eater Advanced™ is the next generation Rain Head, featuring the new patented Clean Shield™(single screen) technology and VH Pivot™ outlet. The Leaf Eater Advanced™ Rain Head prevents debris from entering the Rain Harvesting system, improves water quality and reduces tank maintenance. The single screen incorporates Clean Shield™ technology which deflects leaves and debris away from the flow of water. This minimises maintenance and enhances catchment efficiency. This Rain Head incorporates a VH Pivot™ outlet that swivels to suit vertical or horizontal downpipes. The Leaf Eater Advanced™ can also be used as a debris removing device even when rainwater is not being collected.

Features and Benefits

  • Compact, versatile rain head for quick and easy installation
  • Patented single screen technology for advanced debris shedding (Clean Shield™)
  • Minimal maintenance
  • Pivot the outlet to suit vertical or horizontal (rear outlet) downpipes – variety of installation options in one product (VH Pivot™ patent pending)
  • High flow rate performance
  • Superior catchment efficiency at low and high flow rates
  • Single screen with 0.955mm aperture mosquito proof stainless steel mesh
  • Available in 90mm or 100mm outlet

leaf-eater-advanced-2

Installation Instructions

Gutter & Mid-Mount Installation 1.  Gutter: Measure 208mm from the bottom of the existing gutter pop and remove this section of downpipe. Ensure the cut edge is clean and smooth. Mid-Mount: Remove 208mm of downpipe where the Leaf Eater Advanced™ is to be situated. Ensure all cut edges are clean and smooth. (figure 1) 2.  Using the quick release tabs remove the Cleanshield™ screen by lifting it up and then out. (figure 2) 3.  Insert the Leaf Eater Advanced™ by sliding it up over the cut section and then down into position. The Leaf Eater Advanced™ outlet should be slid firmly onto the bottom down pipe until it can be pushed no further. (figure 3) 4. Screw the Leaf Eater Advanced™ into position through the screw slots provided. Ensure appropriate screws and anchors (if required) are used. (figure 5) 5. Insert the Cleanshield™ screen into the Leaf Eater Advanced™. Ensure the Cleanshield™ screen is sitting firmly in place and check installation is secure. (figure 6) Leaf-Eater-Advanced-Installation Horizontal (Rear Outlet) Installation 1.  Using the quick release tabs remove the Cleanshield™ screen by lifting it up and then out. (Figure 2) 2.  Swivel the outlet to the horizontal position – some force may be required. 3.  Position the Leaf Eater Advanced™ next to existing pipework, mark and cut top and bottom cut lines as per figure 4 . Ensure the cut edge is clean and smooth. 4.  Insert the Leaf Eater Advanced™ by sliding the rear outlet into the horizontal pipe. The back fixing plate must sit behind the top section of downpipe. (figure 3) 5.  Screw the Leaf Eater Advanced™ into position through the screw slots provided. Ensure appropriate screws and anchors (if required) are used. (figure 5) 6.  Insert the Cleanshield™ screen into the Leaf Eater Advanced™. Ensure the Cleanshield™ screen is sitting firmly in place and check installation is secure. (figure 6)